SMB1 Any% Timing
3 years ago
United States

I didn't realize this when I started speedruning SMB1. However, I have learned that the Switch version runs at a slower framerate than an NES or Emulator. After comparing one of my runs that died to bowser on 5:04 pace, I figured out approximately what my time would have been. At least to my knowledge, I was even with a 4:59 I found until 4-2, where I lost a framerule. In 8-1, I lost 2 framerules, and in 8-2, lost 1 more . That puts my run that died to bowser on mid 5:01 pace. In 8-3 and 8-4, no time is lost or gained. That puts my run around 5:01.5, when if it finished it would have been much slower. Is it allowed to adjust my time on the Switch to cancel out the slower FPS? I'm by no means an expert at this game, so it's definitely possible that this is very wrong.

Editado por el autor 3 years ago
Skedaddle les gusta esto
New York, USA

Unfortunately, you cannot adjust your times. You technically have an advantage with running at a slower FR; you have longer reaction time, so it's easier to hit "frame perfect" tricks. If this were allowed, you'd see all top players running at the slowest frame rate possible, and then adjust their times.

Darpey y Capt.Azure les gusta esto
United States

Thank you repusoiram. That's what I was expecting, I just wanted to make sure.

Skedaddle y repuSoiraM les gusta esto
Estadísticas del juego
Seguidores
7,833
Partidas
8,865
Jugadores
1,798
Últimas noticias
Requirements for High-Level Any% Runs

Any% (NTSC) runs below 4:57.000 must now fulfill additional requirements in order to be verified.

  • The run's full session must be included in the submission description.
  • For emulator runs below 4:57.000, some form of input display must be visible for the duration of the run. A hand-cam or input
5 months ago
Últimos hilos
Publicado 4 months ago
25 respuestas
Publicado 5 years ago
1 respuesta
Publicado 14 hours ago
17 respuestas